注意报错提示：% w O7 @8 ^5 X- Q% ]- C
646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.2 i7 a) J" t3 x9 Q2 p2 U
646.04: Travel action ignored.
9 J' s. G& R+ v, ?0 X; d646.04: No debugger information is available.
+ B6 f) q2 q- a646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.: p* V: I5 G! {
646.04: Travel action ignored.9 y2 U8 N# N; q7 A) h
646.04: No debugger information is available.0 u* e! A( L4 i
. ]# B1 C# c& u回来看代码：
3 r! o. g. S' I& e6 f
$ u! T" x7 p' M1 `5 \4 ?begin P_output1 arriving procedure: a2 d# d! W R5 U) m K8 ]
travel to Conv.staoutput1
! P1 s* l' C# }: d8 g move into Q_output(1) 5 F# V9 K" T# ]
/*Location to wait for a vehicle*/+ z- B& @5 L4 z f
travel to Rgv.cpoutput1 /*Get on Vehicle*/
( N) I9 \- d% H; Q( o- ^* ~ send to P_store
2 W! z; A- c/ K; g* Oend ' I1 w; {/ Y5 J, r- }
# ^0 o' Z/ ?6 v; q' E7 p
begin P_store arriving procedure
( ~# b3 p& L4 D5 ]/ D- M: F$ S travel to Rgv.cpstore) c# p. q/ r7 t. t5 n6 U
/* Travel onboard vehicle to cpstore */
9 q% q1 d( f) p- m6 l move into Q_store /* Get off vehicle */
7 H6 F8 a3 x0 z+ B wait for 20 sec
7 ^3 s1 o4 X0 ~4 Z8 p set A_Time to ac - A_Time' M5 `# h( {$ m$ K( ~$ P
print this load, "Time in system " A_Time to message
$ y6 M0 v- @- T inc V_Numdone by 1$ O0 m' ~6 t" h. f$ y3 o: W$ m- v
send to die
/ \ P, Q& C! M- g/ h: ~8 H, _1 qend
& w/ v* X! V+ m7 o. m: u) d1 M8 I
0 Y1 Y$ h! o! C4 O, }知道怎么改了吧？ |
发表于 2009-7-15 21:45:44
