求解

am_simulation

RGV在Q_wait1-6取载后在8个工作站净空、lable
最后在空箱在Q_store流出
目前run model结果发现，货物淤塞在staoutput1-8
未能流出，求解

zhdew

注意报错提示：
646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.
- ?' [0 [4 K' p3 Y, ]) j0 }5 x4 R646.04: Travel action ignored.
6 h1 `+ Q2 S0 @! }646.04: No debugger information is available.
646.04: Load 3 (L_Carton3) is at travel action, but is not on a movement system.
646.04: Travel action ignored.
9 L+ F& B! R% C646.04: No debugger information is available.
4 J. z  T1 W2 X/ O
回来看代码：
: w1 d# H) }1 q+ j$ d2 d( n
begin P_output1 arriving procedure
   travel to Conv.staoutput1
$ D4 C  o$ k3 E' ]4 }* B/ K   move into Q_output(1)
6 ^2 n7 t) I7 K! ]   /*Location to wait for a vehicle*/
    travel to Rgv.cpoutput1 /*Get on Vehicle*/
   send to P_store
end  

begin P_store arriving procedure
' O% b) U' ?, Y* a2 a: ^   travel to Rgv.cpstore
. q( A) Q9 D8 {4 J/ D   /* Travel onboard vehicle to cpstore */
( C; }! s4 |  A! c   move into Q_store /* Get off vehicle */
" S$ Y3 x9 I# r# ]. g' \9 k   wait for 20 sec
5 L7 j3 }  X: }, Q- c! q   set A_Time to ac - A_Time
2 V; s) ~/ `, @6 F; Z% w0 a3 `5 N. J   print this load, "Time in system " A_Time to message
   inc V_Numdone by 1
( C- e  e9 z- K0 U8 L   send to die
end

知道怎么改了吧？