extendsim如何設定派工法則比較

terryhsu2288

/ g1 j& U0 K( M舉例:兩台機器(A和B)分別加工處理兩個訂單(order-1和order-2),
請問機器A要如何設定EDD(最早交期法)?
以及機器B要如何設定SPT(最短加工時間)?
6 i- o, o+ \7 e9 \3 [" f4 u主要比較訂單的流程時間
. N! g0 y7 p5 j! N' S$ ?; _- o, t
' \' y4 y; X( O, E* p修正問題:兩條獨立的產線,各有兩台機器負責加工(A及B),
% _% v, t  Z, N9 L& ~  N' G$ ]訂單(order-1和order-2)分別進入加工,問題是如何設定模塊來表示派工法?

謝謝板主以及各位的幫忙!!

focuscon

比较订单的流程时间？你是指Cycle Time吗，可以用Information模块实现，能否把你的问题说明的再详细一些？
2 N5 `4 G& G  M4 T6 l1.Create+Information
9 b  c2 r+ o3 }" b1 ?You can calculate cycle time by using the Create block's Options tab to assign a Timing attribute to the item when it is generated. Then place an Information block at some later point in the model and select that same attribute as the Timing attribute in the Information block's dialog.
. G7 g4 L$ O) _7 P$ L# ^# U
2.  Set or Equation(I)+Information
' e  k6 x# n5 b5 ^! T( \8 W) wYou can use any Set or Equation(I) block to set an attribute to the current time. Then just reference that attribute in the Information block's dialog.

iesim

呵呵，谢谢 Jeff。
9 J8 {1 t4 A% K, \) {8 l8 ]
3 {  ^% E( [% \) {  H, M/ [7 h下载地址是 http://www.edgestone-it.com/case.htm